Symmetricom S100 Manual de usuario descargar pdf (Pagina 29)

S100 User Guide – Rev. D – June 2005 21

Setting Up the Hardware

On the S100 Front Panel

Complete the following steps before turning on the power:

1. Connect the 9-pin serial cable from the PC workstation to the S100 serial port. You are

doing this so to configure the S100 using a PC; see “Establishing A Serial Connection”

on page 24 in the next section.

2. Connect the RJ45-terminated Ethernet cable to one or both network ports on the S100.

Note: If only one network connection is required, use the left Ethernet port (eth0). The

two USB ports are not functionable on this S100 release.

Sysplex Timer Port: This port

outputs UTC only.

Figure 3-2: S100 Front Panel Close-up

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 165 166

Sin comentarios

Symmetricom S100 Manual de usuario Pagina 29